Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Ok, what am I doing wrong. For some reason when I try and create a back or side panel I get only the top and bottom rails stacked on top of each other at the bottom of the cabinet
Have you tried renumbering your cabinets and then doing a re-draw of the affected cabs? You could also try using the purge plugin to get rid of any extra unused components, then try redrawing.
Can you email me a copy of your .skp file? If it is too large to email try zipping it. I will look at it and get back to you. Else, write me at [email protected] and we can set up an on-line join.me session.
Joe….
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
