[Dan Hawk]

Hi.
Is there a parameter to set where you specify the “offset” of the end sheet in relation to the doors? (Face Frame Cabinets).
When i draw the cabinets, the end sheets line up perfectly with the doors.
I would like to extend the sheets a few mm to allow for easier final assembly.
For the purposes of explaining, I’m attaching a model where I deliberately, manually extended the end sheet (not realistic). Just to show what i am referring to.

https://www.dropbox.com/scl/fi/cn2n5v6f1g9whhbe96958/help_end_panels.skp?rlkey=t3gxji3byy87q7hrti470amet&st=088bxa33&dl=0

Thanks,
Daniel

• This topic was modified 1 year, 6 months ago by Dan Hawk.

[chiefwoodworker]

Hi Dan,

No, there is no parameter for that. However, you can use the Push/Pull tool as you have in your example to extend it, and you might then want to set CabWriter Protection for that part so that when you redraw the cabinet it stays extended.

Joe….

[Author]

Posts