[Dan Hawk]

Hi there,
Need some help please.
Drawing a basic cabinet with a back panel joined to side panel using INSET method.
When the cabinet renders, the position of the groove on the side panel is offset from the position of the back panel joint.
Ive tried to change settings under Carcass/Back but am unable to figure it out.

Any suggestions? Attached screenshots (Ive highlighted the issue in yellow in the picture) and file

Thanks
Dan

Attachments:

You must be logged in to view attached files.

[chiefwoodworker]

Hi Dan,

I need to look at your .skp file, which you were apparently unable to upload here. You might try either crating a IP file and uploading it here, or creating a ZIP file and uploading it to something like Dropbox and emailing the link to me at [email protected] .

Joe…..

[Author]

Posts