Forum Replies Created
-
Posts
-
Thanks Greg
That was it, i guess when i renew i keep thinking the key would be in there. thanks againJoe
when i log in i don’t see a maintenance contract per say but i do see it says my membership is good till Aug. 1 2024Hey Joe i also was trying to update to v7 and i can find the license key i have paid to keep up but not sure where to find the key.
Joe
Well you are probably right on that for sure, i been a dell guy as well but just seeing if there was and common ground on some.Joe,
Thanks for the reply, i will look into chapter 6, i guess my biggest question would be is there a size ratio that works best for this ?Greg
Thanks the was the step i was missing. it been a few years and i forgot how that part worked, thanks againGreg
ok i will work with that on my end.
but to answer yes all the doors parts come out oversized but my drawer fronts do not, i no in my head to make them oversized but i would like to see it on the cutlist if possible.i also just noticed and it just may be that way. if i have say a side of a cabinet oversized it will only show the oversized dimensions on the layout and the finished size will be on the parts list with a finished size. i have in the past never printed the parts list out so maybe that is also why i was not seeing the oversized dimensions.
I also see on my oversizing on drawer front and door panels it only is doing it on the door panels ?
Ok Greg.
I went thru the settings and made changes and looked at the extended entity info as I made them to see what was being oversized. I found some errors on my part and some to say I did not think the are to be changing was the correct field. Like right now I have most of everything working correctly. Here is one thing I am still having problems with. I make my faceframe styles 2 inch wide. I would like them cut oversize by a 1/8 for room to joint and bring into there final width. I can add the 1/8 for the length of rails in the bead allowance settings but I don’t see a place to add the width other than going in the extended entity info and making the change there. Is that my only option?Yes and no. What happens is if I oversize a part it doesn’t show the two different sizes just the one with the oversized and it will say the same thing in the finished size as well. This happens either when I make a part oversized in the extended entity or have the settings in the cutlist on construction side of cabwriter. It only displays the size with the oversized. It’s been this way since I have had cabwriter and I have always just keep a mental note of what things are supposed to be. But I am going to be changing how blank out my sheet stock and need it to be oversized and I need it to be displayed to keep the math easier.
So I even looked in cutlist and I can see on some of the tabs it shows finish size and rough but the info is not being populated from cabwriter
