Forum Replies Created
-
Posts
-
Hi Mark,
Greg and I have discussed adding the architectural angles (< >) that indicate door opening direction. I doubt we have enough time to add it to CabWriter 9, but we can add it to the CabWriter 10 wish list.
Joe….
Hi Jack,
To be honest with you I haven’t yet tested CabWriter 8.0 (or CabWriter 9.0 for that matter) with SketchUp 2026. I will be doing so in the next week or so. SketchUp 2025 definitely works with CabWriter 8.0, so if you can use that for a short while at no extra cost I would recommend it. That said, if you updated to SketchUp 2026 and had a problem with CabWriter you can rest assured I would get on it immediately.
Joe…..
Hi,
The message for this post is not showing up in the Forum. It must be a problem at our end and we are looking into it. In the mean time can you please resend the message to me at [email protected]? Thanks,
Joe….
I don’t see any message in this post. Maybe you can send it to me at [email protected].
Joe….
By the way Mark, you do not need CutList Plus FX to export DXF files. CabWriter can do that on its own. If you don’t know how to do it let me know and we can get together on a Zoom session.
Joe….
Hi Mark,
Glad to hear you have solved the problem. Let me know if you run into further problems.
Joe….Hi Don,
Can you send me a link to your model that demonstrates this problem. Send the link to [email protected]. Thanks,
Joe….
Jack,
Could you send me a link to your model as it is now and let me know when you would be available for a Zoom on-line meeting?
Joe….
Hi Jack,
When you get the prompt to activate the 30-day license click the Yes button. Then you will be operating on a 30-day license for CW 8. I will be out of the office tomorrow morning. But if you are still having problems call me at 413-961-9115.
Joe….
Hi Jack,
We are experiencing an issue on our server that is not permitting user to activate a license. We are working on it and hope to have a solution soon. In the meantime, if you call me on 413-961-9115 we can set up a Zoom meeting and I can get you going with a 30-day trial on CabWriter 8.
Joe…..
Hi Dan,
No, there is no parameter for that. However, you can use the Push/Pull tool as you have in your example to extend it, and you might then want to set CabWriter Protection for that part so that when you redraw the cabinet it stays extended.
Joe….
